Step 5: Install a replacement valve according to package directions and adjust the float to the correct water level. Step 4: Disconnect the water supply line and unscrew the lock nut from outside the tank. Step 1: If they've adjusted the float and the water is still running, try replacing the fill valve, the mechanism that allows the tank to fill with water to the right level. This will lower the float, so the pump turns off sooner and your toilet stops running. Step 2: Bend down the arm, or rod, that connects the float to the pump or turn the small screws on top of the valve to adjust it. The water level should be one-half to 1 inch below the top of the overflow tube if it’s higher, the float needs adjusting. Test the float by flushing the toilet and seeing where the water stops. But if the float is set too high, the water level will rise above the overflow tube or pipe, causing the tank to continuously drain. Replacing flush lever/handle Replacing float rod or float ball Replacing lift wires/tank ball Replacing lift chain and flapper Replacing overflow tube. Step 1: A toilet tank contains a plastic ball that floats on top of the water to indicate when the tank is full. If it’s too short or too long, the chain will prevent the flapper from operating the flush mechanism properly. It should be the same length as the one on the previous flapper. The most common toilet flapper type is a standard rubber flapper, which typically attaches to the base of the overflow tube and sits over the flush valve opening. Be especially careful when adding or removing links to the chain. Step 4: Unhook the flapper from its chain and attach a new one (follow package directions). Step 3: Flush the toilet to drain any water out of the tank and bowl. seal alongside the flush valve which also function alongside the flapper. Step 2: Turn off the water to the toilet-the shut-off valve (a silver knob) should be on the wall, possibly close to the floor, directly behind the tank. Your toilet is trickling water after flushing because your flapper is bad. If the toilet immediately stops running, voila! The flapper isn’t sealing the water properly on its own and needs to be replaced. First have your client check to see if it has deteriorated with this simple test: After taking the lid off the tank, stick a hand in (don’t worry, the water’s clean!) or use a stick and push down on the flapper. Step 1: The flapper, a rubber piece inside the tank that lifts to release water into the bowl when the toilet is flushed, corrodes over time. Whether the problem stems from the flapper, the float or the fill valve, it can be a quick fix! Share these simple, easy-to-understand solutions and your customers will thank you. It sounds like the beginning of a bad joke: A client calls to tell you their toilet is running-your response can't be that they had better go and catch it. A Leaky Fill Valve It is easy to recognize if your overflow tube is not functioning properly, because water will be spilling out the sides of the tank.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |